Service Kits From Bartec USA
March 3, 2021
Bartec USA provide a comprehensive range of Service Kits for all MMY requirements. Many vehicle manufacturers state that the valve stem components are replaced every time the tire is serviced on vehicles with TPMS. Our advice is: “Always remove and replace used snap-in valves when replacing tires. When new tires are installed, it is recommended to also replace all components that are included in the TPMS valve replacement kit.”

OE Sensor Service Kits - This service kit is for OE TPMS Sensors with Aluminum Valve Stems. The typical kit consists of a hex nut, grommet [seal] valve core and dust cap.

OE Aluminum Valve Kits - This service kit is for OE TPMS Sensors with replaceable aluminum valves. The typical kit consists of a new valve, grommet [seal], hex nut, valve core, screw, and dust cap.

OE Rubber Valve Kits - This service kit is for OE TPMS Sensors with replaceable rubber valves. The typical kit consists of a new valve, valve core, screw, and dust cap.

Starter Kit and Cabinet - This service kit is for OE TPMS Sensors with replaceable rubber valves. The typical kit consists of a new valve, valve core, screw, and dust cap.

Other Articles
Bartec TPMS Product Catalog Fall/Winter 2025 Launched
October 8, 2025
Visit Bartec TPMS At SEMA & Discuss Our Next Software Release R8.1
October 6, 2025
TPMS Tips For Servicing HP/UHP Tires
October 3, 2025
2025 Global Tire Expo At The SEMA Show
October 2, 2025
TPMS Service Survey
October 1, 2025
Get More With TechRITEPro Bundle Deals From Bartec TPMS
September 25, 2025
No One Does Toyota TPMS Better Than Bartec TPMS
September 19, 2025
Bartec TPMS Attend The Canadian Tire Dealers Association Products Parade
September 17, 2025
Why Does The TPMS Light Cause So Much Stress
September 12, 2025
Own The Wheel Well WIth Bartec TPMS
September 9, 2025